Samsung STREAM 83I - Manual (Page 14)

13
Connecting to your computer network - cont.
13. If your network is not found, it may be because the router is configured not to broadcast the SSID. You
should then use the Tuning/Select control to highlight and select the '[Manual config]' option in order to
enter the network details manually. This is described in 'Manual Network Configuration', see page 16.
If your network name is being broadcast, and it was not found, then try re-scanning (press the Back button),
and if necessary try moving your sound system to a location closer to your access point / router.
14. When the SSID for the wireless network you wish to connect to is highlighted on the screen, press the
Select control. If WiFi Protected Setup (WPS) was indicated, you will see an additional menu at this point,
otherwise proceed to step 15.
Choose one of the WPS menu options as required for your router (WPS may be via push button, or using
an identification number).
'Push Button' - the display prompts you to press the WPS button on your router and then the Select control
on the sound system. The two devices should then connect with the encryption key sent automatically to
the sound system.
'PIN' - the display shows an identification number which you must enter into your router using a web browser
(refer to your router's user documentation). You should then press the Select control on the sound system.
The two devices should then connect with the encryption key sent automatically to the sound system.
'Skip WPS' - if you wish to enter the encryption key yourself (or if it was previously entered).
If you chose Push Button or PIN the screen will then show 'Connecting...' and then 'Setup wizard completed'.
Press the Select control to exit setup wizard and then go to paragraph 18 on the next page.
15. If your network is configured without an encryption key, the screen should say 'Connecting...', and then
'Setup wizard completed'. Press the Tuning/Select control to exit the setup wizard and show the main
Internet Radio menu. If this is the case then you have successfully connected your sound system to your
network, so please go to paragraph 18 on the next page.
16. If the screen displays 'Key:', it is because the network is using one of the encryption systems: Wired
Equivalent Privacy (WEP) or WiFi Protected Access (WPA). You will need to enter the correct WEP or
WPA key into the sound system to allow it to communicate with your wireless network. If you do not have
the WEP or WPA key, then you should obtain it from the person who set up your network. Some wireless
routers may come with an encryption key already set up by the supplier, in which case you should refer
to the documentation provided with it. WPA is used here to also include WPA2.