Samsung STREAM 83I - Manual (Page 15)

If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri) 14
Configuration .
Connecting to your computer network - cont.
WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Some wireless
routers can also use pass-phrases for WEP but these are not supported. WPA
keys are usually set up using a pass-phrase of between 8 and 63 characters.
Your sound system accepts pass-phrases for WPA keys.
17. To enter the WEP or WPA key, characters are selected and entered using the
Tuning/Select control. As you rotate the control, the highlight scrolls through
the available characters as well as the three controls on the right. The character
currently highlighted will be entered when you press the Tuning/Select control.
Do this as needed until the complete key has been entered. Remember, WEP
keys only use the numbers 0-9 and letters A-F. WPA keys are sensitive to upper
and lower case characters. You must enter the key exactly or the sound system
will not connect to the network.
The three controls on the right-hand side of the screen have special functions.
You can quickly access these by pressing the Info button and then use the
Tuning/Select control as needed:
select ' ' to erase a character just entered (long press to clear)
select ' ' when the complete key has been entered
select ' ' to cancel and re-run the Network Wizard
If a WEP or WPA key has previously been entered for the selected SSID then
the display will show 'Key: [Set]'. If you have previously entered a different key,
you must clear this by selecting the ' ' symbol. This will remove the '[Set]'
indication.
After the final character of the WEP or WPA key has been entered, highlight the ' '
symbol and press the Tuning/Select control. The screen will show 'Connecting...'
and then 'Setup wizard completed'. Press the Tuning/Select control to the exit
setup wizard. The sound system should now be able to connect to the network.
18. Once you have connected your sound system to the network (and therefore also
to the Internet) it will display the main Internet Radio menu. Press the On/Off
button to put the sound system in Stand-by mode. It should then display the time
as obtained from the Internet. If the time display is not correct for any reason, it
can easily be adjusted later, see page 72, 'Manually setting the clock'.
13-18
18