1 typical current profile, 2 conducted noise, 3 voltage tolerance – Seagate Barracuda ST3300631A User Manual
Page 19: Figure 1, Typical 5v startup and operation current profile, Figure 2, Typical 12v startup and operation current profile
Barracuda 7200.8 PATA Product Manual, Rev. F
13
2.8.1.1
Typical current profile
Figure 1
Typical 5V startup and operation current profile
Figure 2
Typical 12V startup and operation current profile
2.8.2
Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on
the +12 volt line or an equivalent 15-ohm resistive load on the +5 volt line.
• Using 12-volt power, the drive is expected to operate with a maximum of 120 mV peak-to-peak square-wave
injected noise at up to 10 MHz.
• Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave
injected noise at up to 10 MHz.
Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write
current.
2.8.3
Voltage tolerance
Voltage tolerance (including noise):
5V ± 5%
12V ± 10%