Before calling for service, Symptom check remedy – Samsung 20060510083254531 User Manual

Page 47

Advertising
background image

46

Before Calling for Service

Symptom

Check Remedy

Can't turn it on.

It does not work when the

button is pressed.

Sound is not produced.

Picture does not appear when

the function is selected.

Is the power code plugged into the outlet?

Is there static electricity in the air?

Are the speaker and external

component connected properly?

Does the Mute function work?

Is the volume set to minimum?

Is the speaker setup selected to

NONE?

Isn’t the external component connected

properly?

Connect the power plug to the outlet.

Disconnect the power plug and connect it

again.

Properly connect it.

Properly connect it.

Press Mute button to cancel the function.

Adjust the volume.

Refer to pages 20~21 to select LARGE,

SMALL or YES.

There is no sound from

center speaker

Is the center speaker connected properly?

Is C.SPK (Center) selected to NONE in

Speaker Setup?

Is the Surround Mode selected to Stereo?

Refer to pages 10~11 to connect it properly.

Refer to pages

20~21

to select LARGE or

SMALL.

Refer to pages 30~37 to select other

Surround Modes.

Remote controller does

not work.

There is no sound from

surround speaker.

The sound from each
device is changed during
stereo playback.

Can't receive

broadcasting.

Is AM or FM antenna connected

properly?

Are the batteries exhausted?

Is the distance between remote

control and main unit proper?

Is the surround speaker connected

properly?

Is S.SPK (Surround) set to NONE in

Speaker Setup?

Is Surround Mode selected to Stereo?

Refer to pages 10~11 to connect it properly.

Refer to pages

20~21

to select LARGE or

SMALL.

Refer to pages 30~37 to select other

Surround Mode.

Replace with new batteries.

Operate at close distance.

Properly connect the antenna.

If the input strength of antenna connector

is weak, install the FM antenna in a place
with good reception.

Is the left/right speaker or left/right

input/output code connected
properly?

Check the left/right channel and properly

connect it.

AV-R610 XAC ENG-1 5/5/06 14:4212:0 Page 46

Advertising
This manual is related to the following products: