Samsung Eternity II SGH-A597 - Manual (Page 13)

Getting Started 8
2. Plug the data cable into the base piece provided and into
the Power/Accessory Interface connector on your phone.
3. Plug the base piece into a standard AC wall outlet.
4. When the battery is fully charged, the phone displays a
message telling you the battery is full. Remove the
connector from the phone.
Warning!: If your handset has a touch screen display, please note that a
touch screen responds best to a light touch from the pad of your
finger or a non-metallic stylus. Using excessive force or a metallic
object when pressing on the touch screen may damage the
tempered glass surface and void the warranty. For more
information, refer to “Standard Limited Warranty” on page 181.
Note: Failure to unplug the wall charger before removing the battery, can
cause damage to the phone.
Low Battery Indicator
When the battery is weak and only a few minutes of talk time
remain, the battery icon (
) blinks and the device sounds a
warning tone at regular intervals. In this condition, your phone
conserves its remaining battery power, not by turning off the
backlight, but by entering the dimming mode. For a quick check
of your battery level, glance at the battery charge indicator
located in the upper-right corner of your device’s display. Five
bars (
) indicate a full charge.
When the battery level becomes too low, the phone automatically
turns off.
Switching the Phone On or Off
1. Press and hold or until the phone switches on.
The phone launches the activation splash screen and then
proceeds to search for the network. Once the network has
been found, you can make or receive calls. To lock your
phone, see “Security” on page 59.
Correct
DA TA LINK CABLE
Incorrect
Incorrect Correct