Sharp UP-820F - Manual (Page 15)

13
When you have completed the programming at the master, you can distribute the preset data from the
master to all or desired satellites in the IRC system.
(1) Initial downloading
For initial setup of the IRC system, follow the downloading procedure below. When the preset data in
the master is downloaded to each satellite, existing preset data in the satellite, if any, is cleared.
1.
Enter the PGM2 mode from the mode selection window.
2.
Select “INITIAL D/L” and press the
e
key.
The INITIAL D/L window will appear.
3.
If you wish to distribute all preset data files in the master to
satellites, select “ALL PGM” and press the
e
key. If you
wish to distribute an individual preset data file, select the
corresponding data item and press the
e
key.
Enter an appropriate code range if needed.
The MACHINE No. window will appear.
4.
If you wish to download the preset data to all satellites, select
“ALL” and press the
e
key. If you wish to download the data
to certain satellite(s), select “MACHINE SELECT” and press
the
e
key. In this case, the MACHINE SELECT window will
open.
Move the cursor to the corresponding machine numbers,
select “YES,” and press the
c
key.
Check the contents of the programming of all the satellites in the IRC system that have received
the preset data.
NOTE
8. Downloading the contents of the programming to satellites – master