Sharp UX-D50 - Manual (Page 67)

Operating the Answering System
65
3. Ans
w
er
ing
Machi
n
e
To listen to the outgoing message
To listen to the outgoing message, follow Steps 1 and 2 of the above
procedure and then press . Note that the general outgoing
message cannot be erased. If you need to change it, simply repeat the
recording procedure.
Operating the Answering System
Activating the answering system
To turn on the answering system so that callers can leave messages, press
until the arrow in the display points to A.M.
WIEDERG./
HALTEN
AUFLÖS./
EMPFANG
4
Press and speak into the handset to record a message.
•
The outgoing message can be up to 60 seconds long. While recording, the
display will show the time left to record.
5
When finished, replace the handset or press .
START/SPEICHER
STOP
AUFLÖS./
EMPFANG
♦
The outgoing message will play (you can stop playback by pressing
).
♦
It will not be possible to set the reception mode to A.M. if an outgoing
message has not been recorded.
STOP
FAX TEL
AB TEL/FAX
all.book Page 65 Monday, September 1, 2003 3:46 PM