Sennheiser EM 3731 User Manual
Page 34
32
The operating menu
external word clock generator is not connected or switched off), the
display for external word clock synchronization
B
starts flashing and
the last set sampling rate remains active.
The receiver’s audio outputs have a latency which depends on the sam-
pling rate set in the “
Clock
” menu. The below table shows these latency
times as well the the distances to which they approximately correspond.
Configuring the audio outputs of the EM 3732 Command twin receiver
Command
The EM 3732 Command twin receiver has two audio outputs per receiver:
1. the audio outputs AF out 1
and AF out 2
,
2. the command outputs Command 1
and Command 2
These audio outputs can be switched on and off via a button on the
transmitter – provided that the transmitter is also equipped with the
command function (a separate power pack with command button is
available for the SKM 5200 transmitter).
Via the “
Command
” menu, you can determine which of the audio and
command outputs are switched on and off when the command button on
the transmitter is pressed. There are four configuration options:
The active output lights up in the command display; muted outputs are not
displayed (see “Command display (status display of the audio outputs AF
and COM)” on page 11).
Audio output
Sampling rate
kHz
Latency
ms
Corresponds to a
distance of
approx. ... cm
analog
44.1 / 88.2
1.8
60
analog
48 / 96
1.7
55
digital
44.1
1.9
65
digital
48
1.7
55
digital
88.2
1.8
60
digital
96
1.7
55
If the “Command”
menu of the receiver is
configured as shown
below …
… AND the
command button
on the transmitter
is …
… THEN the
receiver’s audio
outputs are
switched ...
not pressed
AF out:
on
Command:
off
pressed
AF out:
on
Command:
on
not pressed
AF out:
on
Command:
off
pressed
AF out:
off
Command:
on
not pressed
AF out:
on
Command:
on
pressed
AF out:
off
Command:
on
not pressed
AF out:
on
Command:
on
pressed
AF out:
on
Command:
on
1
AF
COM
AF
AF
AF
COM
2
AF
COM
AF
COM
3
COM
AF
COM
AF
COM
COM
4
COM
AF
COM
AF
AF
COM
AF
COM