Sennheiser EM 3731 - Manual (Page 38)

36
The operating menu
Selecting the status display
Display Via the “ Display ” menu, you can select the status display:
̈
Change to the setting mode of the “ Display ” menu.
The current status display starts flashing.
̈
Select one of the four status displays by turning the jog dial 7 .
̈
Press the save button 8 .
The selected status display becomes effective. The display changes to
the selection mode of the operating menu.
Changing the IP address
IP-Addr Via the “ IP-Addr ” menu, you can display and change the receiver’s IP
address. The IP address consists of four bytes and each byte consists of up
to three digits (from 0 to 255). The receiver is factory-preset to dynamic
IP addressing (“Auto”).
To manually assign an IP address:
̈
Change to the setting mode of the “ IP-Addr ” menu.
The first byte starts flashing.
̈
Select a value between 0 and 255 by turning the jog dial 7 .
̈
Press the jog dial 7 to confirm the first byte and change to the next
byte.
̈
Repeat the last two steps to select all four bytes.
̈
After you have selected the complete IP address, press the save button
8 .
̈
Switch the receiver off and on again (see “Switching the receiver on/
off” on page 19).
The new IP address becomes effective.
Selectable status display Contents of the display
1. “ Name ”
displays the freely selectable name
2. “ Bank/Channel ”
displays the frequency bank and the
channel number
3. “ Name/Command ”
displays the freely selectable name
and the command display
(EM 3732 Command receiver only)
4. “ Bank/Channel/Command ”
displays the frequency bank, the channel
number and the command display
(EM 3732 Command receiver only)
M
H
z
790.800
NAME
M
H
z
790.800
BANK
CH 03.03
M
H
z
790.800
NAME
COM AF
M
H
z
790.800
BANK
CH 03.03
COM AF
1
NAME
790.800
esc
s ave
syn c
digital audio
processing
syn c
DEV M H
z
790.800
03.03 BANK
CH
COM AF
192.
168.
0.
0
Auto
192 .
049 049.
068 068.
esc
s ave
syn c
digital audio
processing
syn c
DEV M H
z
790.800
03.03 BANK
CH
COM AF