Scotts SP6213 - Manual (Page 11)

Operating - 7
OPERATING
3. If bag prevents lowering of handle, remove clip (F) to
remove rod (G). Remove rod from lower position (H) and
insert in upper position as shown to lengthen bag.
4. Tighten knob (C) on each side of handle.
Starting Engine
1. Prime engine by pressing primer bulb (A):
• COLD Engine - 3 times
• WARM Engine - 1 or 2 times
2. Hold blade control lever (B) against handle.
3. Pull starter handle until you feel resistance. Then pull
fast and steady.
4. When engine starts, return rope slowly.
c
CAUTION: Avoid injury! Engine exhaust fumes
can cause sickness or death.
Run engine only in a ventilated area.
If engine is run in an enclosed area, open doors
to bring in outside air.
IMPORTANT: Avoid damage! To help prevent
damage to recoil starter and band brake, do not start
engine:
• When blade is under load, such as, in heavy
grass.
• When blade control lever is released.
M96559
F
G
H
MX1568
A
c
CAUTION: Avoid injury! WHEN ENGINE IS
RUNNING, BLADE IS TURNING.
Keep hands, feet and clothing away from the
blade.
B
M93034
M88828