Sennheiser EW100 G2 - Manual (Page 16)

16
To mount two EM 100 G2 into a rack:
̈
Place the two receivers side by side onto a flat sur-
face, their bottom sides facing upwards.
̈
Align the connecting plate
Ƽ
over the holes in the
bottom sides of the receivers.
̈
Secure the connecting plate
Ƽ
to the receivers
using eight of the supplied recessed head screws
(M 3x6).
̈
Hook the two rack mount “ears”
ƺ
to the front
panels of the receivers.
̈
Secure the rack mount “ears” to the receivers using
two of the supplied recessed head screws (M 3x6)
respectively.
̈
Slide the receivers into a 19” rack.
̈
Screw the rack mount “ears” tight.
When mounting only one receiver into a rack, use the
connecting bar
ƻ instead of the second receiver.
̈
Hook the two rack mount “ears”
ƺ
to the front
panel of the receiver.
̈
Secure the rack mount “ears” to the receiver using
two of the supplied recessed head screws (M 3x6)
respectively.
̈
Secure the connecting bar
ƻ
to one of the rack
mount “ears”
ƺ
using two of the supplied recessed
head screws (M 6x10).
̈
If you are not front mounting the antennas, insert
the two covering plugs
ƽ
into the antenna holes of
the connecting bar.
̈
Slide the receiver into a 19” rack.
̈
Screw the rack mount “ears” tight.
To mount the receiver’s antenna connection to the
front of the GA 2 rack adapter using the AM 2 antenna
mount:
̈
Screw the two BNC sockets
ƾ
of the BNC extension
cables to the connecting bar
ƻ
using the supplied
plain washers and nuts.
̈
Connect the two BNC connectors
ƿ
to the BNC
sockets
¸
and
Ƹ
at the rear of the receiver.
̈
Slide the receiver into a 19” rack.
̈
Screw the rack mount “ears” tight.
̈
Connect the two telescopic antennas
ƹ
to the two
BNC sockets
ƾ
.
̈
Pull the telescopic antennas out and align them
upwards in a V-shape.
ƺ
ƺ
Ƽ
ƻ
ƺ
ƺ
ƽ
ƿ ƾ ƻ
ƹ