Sennheiser EW100 G2 - Manual (Page 13)

13
Indications and displays on the transmitters
Operation and battery status indication
The red LED (LOW BAT/ON) provides information on the current operating
state of the transmitter:
Red LED lit up: The transmitter is switched on and the capacity of the
batteries/accupack BA 2015 is sufficient.
Red LED flashing: The batteries are/the accupack BA 2015 is going flat (LOW
BAT)!
In addition, the 4-step battery status display
ብ
on the display panel provides
information on the remaining battery/accupack BA 2015 capacity:
“MUTE” display
The “MUTE” display
ቨ
appears on the display panel when the transmitter is
muted (see: „Muting the transmitters“ on page 23).
Modulation display
The level display for audio signal (AF) shows the modulation of the transmit-
ter.
AF peak indication (SK 100 G2 only)
The yellow LED (AF PEAK) ᕤ at the front of the SK 100 G2 lights up when the
audio input level is excessively high (AF peak) and overmodulates the trans-
mitter. At the same time, the 7-step level display for audio signal “AF” shows
full deflection for the duration of the overmodulation.
“PILOT” display
The “PILOT” display
ቧ
lights up when the transmitter display panel if the
pilot tone transmission is activated (see: „Activating/deactivating the pilot
tone transmission or pilot tone evaluation“ on page 35).
Display backlighting (SK 100 G2 only)
After pressing a button, the display remains backlit for approx. 15 seconds.
ብ
3 segments: capacity approx. 100 %
2 segments: capacity approx. 70 %
1 segment: capacity approx. 30 %
Battery icon flashing: LOW BAT
ቨ
¿
ቧ