Sennheiser EW100 G2 - Manual (Page 20)

20
Plugging the plug-on transmitter onto a microphone
̈
Plug the transmitter’s XLR-3F socket
ᕡ onto the microphone’s XLR-3M socket.
̈
Tighten the locking ring
ᕢ
as shown in the diagram on the left.
Note:
The transmitter uses the microphone body as an antenna – therefore only
microphones with a metal casing should be used for best signal transmission.
SKM 100 G2 radiomicrophone
Inserting and replacing the batteries
For powering the SKM 100 G2 radiomicrophone, you can either use two 1.5 V
AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
̈ Unscrew the display section ᕥ from the radiomicrophone’s body ᕣ by
turning it counterclockwise.
̈
Slide back the display section
ᕥ
as far as it will go.
̈ Open the battery compartment cover ƹ .
̈
Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
̈
Close the battery compartment cover
ƹ
.
̈ Push the battery compartment into the radiomicrophone’s body.
̈
Screw the display section tight.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries“ on page 19.
³ ·
´
ƹ
´ »