Sennheiser EW100 G2 - Manual (Page 35)

35
Loading the factory-preset default settings
RESET
Via the “ RESET ” menu, you can load the factory-preset default settings. Only
the selected setting for the pilot tone remains unchanged. After the reset, the
unit is restarted and the standard display is shown on the display panel.
Activating/deactivating the pilot tone transmission or
pilot tone evaluation
PILOT
Via the “ PILOT ” menu, you can activate or deactivate the pilot tone transmis-
sion of the transmitters and the pilot tone evaluation of the receivers.
The pilot tone supports the squelch function (SQELCH) and protects against
interference due to RF signals from other units. The transmitter adds an inau-
dible signal, known as the pilot tone, to the transmitted signal. The receiver
detects and evaluates the pilot tone, and is thus able to identify the signal of
the matching transmitter and mute all others.
Transmitters of the ew 100 series (first generation) do not transmit a pilot
tone and receivers of the ew 100 series (first generation) cannot evaluate
the pilot tone. Nevertheless, you can combine units of the ew 100 series (first
generation) with units of the ew 100 G2 series (second generation).
However, when combining units, please observe the following:
y With an ew 100 G2 transmitter and an ew 100 G2 receiver:
Activate the pilot tone function with both transmitter and receiver.
y With an ew 100 transmitter and an ew 100 G2 receiver or vice versa:
Deactivate the pilot tone function with the ew 100 G2 transmitter or recei-
ver.
Activating/deactivating the lock mode
LOCK Via the “ LOCK ” menu, you can activate or deactiveate the lock mode.
The lock mode prevents that the transmitter or receiver is accidentally pro-
grammed or switched off during operation. The lock mode icon on the display
indicates that the lock mode is activated.
To deactivate the lock mode, first press the SET button. Then press the
̆
/
̄
buttons to select “Lock Off”.If you confirm your selection by pressing the SET
button, “LOC.OFF” appears on the display and the buttons can be operated as
usual.
Exiting the operating menu
Via the “ EXIT ” menu, you can exit the operating menu and return to the stan-
dard display.
EM 100 G2
EK 100 G2
Trans-
mitters