Your new wide tv, Rear panel jacks – Samsung Tantus HLM 437W User Manual

Page 8

Advertising
background image

Rear Panel Jacks

Use the rear panel jacks to connect components such as a VCR.
You can connect two different components such as two VCRs, Set-Top Box and a DVD player etc.,
because there are two sets of video input jacks and one set of component video input jacks on the rear
panel of your TV. For more information, please see “Connections”.

15

Front Panel LED Indicators : HLM4365W/HLM5065W

The three lights on the front panel indicate the status of your TV.

Indicator Light Key

Your New Wide TV

14

: Light is On
: Light is Blinking

: Light is Off

• It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
• The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.

ΠANTENNA terminals

Two independent cables or antennas can be connected to these termi-
nals. Use ANT-A and ANT-B terminals to receive a signal from
VHF/UHF antennas or your cable system. Use the ANT A-OUT termi-
nal to send the signal being received by the ANT-A terminal out to
another component (such as a Cable Set Top Box).
The PIP channel can be received only when a signal source is
connected to ANT-A.

´ S-VIDEO INPUT jacks

Connects an S-Video signal from an S-VHS VCR or DVD player.

ˇ VIDEO/AUDIO INPUT jacks(VCR1, VCR2)

Connect video/audio signals from external sources, such as a VCR or
DVD players.

¨ VIDEO/AUDIO MONITOR OUTPUT jacks

Sends a video signal from the TV to an external source, such as a
VCR.
Note: Monitor Out is available only in RF, Video and S-Video modes.

ˆ Component1 jacks (Y, P

b

, P

r,

L, R)

Use these jacks to connect the component video/audio signals from a
DVD player when using the component video input jacks.
Note: Only 480i and 408p formats are supported.

Ø Component 2, 3 jacks (Y, P

b

, P

r,

L, R)

Receives the DTV video/audio signals from a set top box.
Note: Only 480p, 720p and 1080i formats are supported.

PC AUDIO INPUT jacks

Connect these to the audio-output jacks on your PC.

DVI (Digital Video Interface) jack

Receives the digital signals from a set top box or PC etc.

RS-232C jack

˝ PC VIDEO INPUT jack

Connect to the video output port on your PC.

Timer

Lamp

Temp

Indication

Auto Timer ON/OFF has been set

The set is operating normally .

Standby state.

The picture will automatically appear in about 25 seconds.

Auto Timer ON/OFF has been set and the set is normally operating.

Auto Timer ON/OFF has been set and the set will automatically be turned on in

about 25 seconds.

A cooling fan inside the set is not operating normally.

Lamp cover on rear of the set is not properly shut.

Check if the ventilation hole on the rear of the set is blocked, because if the

inner temperature is too high, the power will shut off.

Lamp may be defective. Please contact a certified technician.

Advertising
This manual is related to the following products: