Sharp AR-337 - Manual (Page 132)

7-20
CHAPTER
7
Offset stack
In the initial setting, the top tray is selected.
To select the offset tray, press the OUTPUT key and then the
“OFFSET TRAY” key on the touch panel.
If the offset tray is selected, each copy set will be offset by a minimum
of 61/64 inch.
When the offset stack function is disabled, copies will not be offset.
The offset stack function can be enabled or disabled by pressing the
“OFFSET” check mark box on the touch panel.
When the STAPLE SORT mode is selected, the offset stack function
will be disabled.
If the offset tray is selected, only 8-1/2" x 11" paper can be used.
The top tray cannot be used to offset copies.
OFFSET mode
When copying in the SORT mode, each collated set of
copies will be stacked offset a minimum of 61/64 inch
from the previous set. When copying in the GROUP
mode, copies will be offset and stacked in groups of
multiple copies from the same original.
NON-OFFSET mode
All copies will be aligned in one stack in the offset tray or
the top tray with no offset.
OUTPUT
TOP TRAY
OFFSET
SO
OFFSET
TRAY
AUTO AUTO 8
1
2
3
1 2
1
1 1
1
1
1
2
3
1
OPTIONAL EQUIPMENT
Finisher (AR-FN2)
FINISHER (AR-FN2)