Southbend SSB-45 - Manual (Page 12)

I NSTALLATION R ADIANT S TEAKHOUSE B ROILER
S TEP 2 A : M OUNT ON H EAVY D UTY S TAND
The stand is crated separately, but is shipped with the broiler. Depending on the shipping requirements, the broiler
may already be assembled to the stand.
1. The broiler will be attached to the stand using four ¼"-20 bolts and lock washers provided with the stand.
Remove the bolts and lock washers from the stand.
2. Lift the broiler (using two people is recommended). (Depending on the size and weight of the unit, it may be
helpful to remove the griddle plate before lifting the broiler. To do so, remove the body sides to access griddle
plate mounting bolts.) Place the broiler on the stand so the holes in the mounting flange align with the
corresponding holes in the stand. The valve panel flange should sit flush with front frame of the stand. Secure the
broiler to the stand with the ¼"-20 bolts and lock washers.
3. Go on to Step 3.
Figure 4
Mounting Broiler on Stand
Fasten broiler to stand with four 1/4-inch bolts here.
If assembled broiler is too heavy to lift, remove side panels
and then remove griddle top by removing four bolts.
P AGE 12 OF 20 O WNER ’ S M ANUAL 1190950 (02/09)