Sony STR-DG1000 - Manual (Page 101)

101 GB
O
ther O
p
e
ra
tions
To operate the receiver using an
IR repeater
You can operate the receiver without pointing
the remote toward the IR sensor of the receiver
if you use an IR repeater.
Use an IR repeater when you install the
receiver in a place where signals from the
remote cannot reach.
Using a bi-amplifier
connection
If you are not using surround back speakers,
you can use the SURROUND BACK
SPEAKERS terminals for the front speakers
for use with a bi-amplifier connection.
To connect speakers
Connect the terminals on the Lo (or Hi) side of
the front speakers to the FRONT SPEAKERS
A terminals, and connect the terminals on the
Hi (or Lo) side of the front speakers to the
SURROUND BACK SPEAKERS terminals.
Make sure that metal fittings of Hi/Lo attached
to the speakers have been removed from the
speakers. Not doing so may cause a
malfunction of the receiver.
To set up speakers
Set “SUR BACK SP” to “BI-AMP” in the
Speaker Settings menu (page 67). The same
signals output from the FRONT SPEAKERS
A terminals can be output from the
SURROUND BACK SPEAKERS terminals.
IR repeater
(not supplied)
STR-DG1000
RM-AAL003
Front speaker
(R)
Front speaker
(L)
Hi
Lo
Hi
Lo
continued