Samsung FER300 - Manual (Page 42)

42_ Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Oven not clean after
a self-cleaning cycle The oven controls were not set
correctly. See the section on self-cleaning on page •
31.
The oven was heavily soiled. Wipe up heavy spillovers before starting •
the self-cleaning cycle. Heavily soiled
ovens may need to self-clean again or for
a longer period of time.
Steam from the vent When using the convection
feature, it is normal to see steam
coming out of the oven vent.
This is normal. •
As the number of racks or amount
of food being cooked increases,
the amount of visible steam will
increase.
Burning or oily odor
emitting from the
vent This is normal in a new oven and
will disappear in time. To speed the process, set a self-cleaning •
cycle for a minimum of 3 hours.
See the section on self-cleaning on page •
31.
Strong odor An odor from the insulation around
the inside of the oven is normal
for the first few times the oven is
used. This is temporary. •
Oven racks are
difficult to slide. The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle. Apply a small amount of vegetable oil to •
a paper towel and wipe the edges of the
oven racks with the paper towel.
Display goes blank. A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit •
breaker.
Display flashes. There was a power failure. Reset the clock. •
Drawer does not
slide smoothly or
drags. The drawer is out of alignment. Fully extend the drawer and push it all the •
way in. See the page 38.
The drawer is over-loaded or the
load is unbalanced. Reduce weight. Redistribute drawer •
contents.
FE-R300_XAA DG68-00277A.indd 42 2010-01-20 �� 12:10:00