Samsung HT-DL200 - Manual (Page 20)

38
Troubleshooting
• Is the disc installed with the label side facing up?
• Is the power cord plugged securely into the power outlet?
• Turn off the power to the unit by pressing the Power ( ) button
and turn it back on.
• Check the region number of the DVD.
• DVD discs purchased abroad may not be playable.
• This player cannot play CD-ROMs, DVD-ROMs, etc.
• Check the rating level of the DVD.
• Check whether the disc has any scratch marks or is deformed?
The disc tray does not
open.
Disc does not play.
Playback does not start
immediately when the
Play/Pause button is pressed.
• No sound is heard during high-speed playback, slow playback,
and step motion playback modes.
• Are the speakers properly connected? Is the speaker Setup
correctly customized?
• Is the disc severely damaged?
The disc may be dirty. Wipe off fingerprints or dirt.
No sound is produced.
• Was the player moved suddenly from a cold pace to a warm one?
When condensation forms inside the player, remove the disc
and let the player stand for 1 or 2 hours with the power on.
(You can use the player after the condensation disappears.)
Picture does not appear; sound
is not produced; the disc tray
opens 2-5 seconds later.
• Are the speaker cables loose?
• Is there any dirt or debris at the end of the speaker connector?
Sound quality is
irregular.
• When listening to a CD or radio, sound is output to the front
speakers only (L/R). Select the “PRO LOGIC” option by pressing
the Pro Logic button on the remote control unit to use all six
speakers.
• Check whether your DVD disc is 5.1 CH compatible.
Sound can be heard only
from a few speakers and
not all six.
• Does the disc being played show the “Dolby Digital 5.1CH” mark ?
5.1-channel sound is reproduced only if the disc is recorded with
5.1 channel sound.
• Is the DVD player connected to the proper speakers?
Dolby Digital 5.1 Channel
Surround Sound is not
being reproduced.
Problem Check
Sleep Function
37
To set up Sleep
• Each time the button is pressed the selection
toggles as follows: SLEEP 10
➔ SLEEP 20
➔ SLEEP 30 ➔ SLEEP 60 ➔ SLEEP 90
➔ SLEEP 120 ➔ SLEEP 150 ➔ OFF.
• The remaining time for the selected Sleep time is displayed.
• Pressing the button once again changes the Sleep time from the
last setting.
Sleep
Press the Sleep button.
What is the
Sleep function?
You can set the delay time so that
the unit powers off automatically
after a preset period of time.
To Review Sleep Setting