Samsung HT-DL200 - Manual (Page 8)

• The “WAIT” message that appears on the display for about seven to eight seconds when
turning on the power or selecting a DVD function indicates a stabilization period for
optimizing the condition of your DVD player. While the message is being displayed, other
buttons remain inactive.
• When the power is not turned on, press down the Stop ( ) button on the main unit for
over 5 seconds.
The inside of the product will be initialized to its optimum state.
• If your TV model is not SAMSUNG, refer to “Remote Control Unit Setup” on page 28.
Before Using the DVD Player
14
• Your DVD player can also play CD-R and CD-RW discs recorded in digital
audio format. When recording your own CD-R or CD-RW discs, make sure that
the recording session is properly terminated, or they will not be playable.
(Depending on disc properties and recording quality, some CD-R/RW may not
be playable.)
• CD-RW has a lower reflection rate than CD-R media and consequently it will
take a longer to read CD-R discs.
• CD-RW discs recorded at high speed tend to be difficult for the DVD player to
read. If the recording speed for the CD-RW disc is not predetermined, write it
at low speed.
CD-R/RW playback compatibility
Your DVD player is capable of playing DVD, VCD, and CD discs.
User instructions may vary depending on the type of disc. Read the instructions
carefully before use.
TV TV/VIDEO DVD
Prepe-
rations
before
use
Turn on the power
to your DVD player
and TV.
1
Select a video mode by
pressing the TV/VIDEO
button.
2
Press the DVD button
to select the DVD input
function.
3
Zoom
TV System
TV System Selection
Press the TV System button while in stop mode.
• Each time the TV System button is pressed, “ NTSC , PAL ” are
selected in this order.
Different countries use different types of TV broadcast systems, video,
audio and channel systems.
Example : The player cannot playback PAL-encoded DVD with NTSC-TV.
13
Connecting your System to the Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check the voltage.
Check the position of the voltage selector on the rear of the system (OPTIONAL).
1. Plug the main lead (marked AC Cord on the rear of the system) into an appropriate socket.
2. Press the On/Standby button to switch your DVD Player system on.
V I D E O
Function
Volume
Phones
Listening on headphones
Use headphones for private listening pleasure (not supplied).
Connect the headphones to the HEADPHONES jack of the front panel.
• No sound is produced from the speakers.
• To prevent hearing damage, do not raise the volume level excessively when
using headphones.
HEADPHONE jack
R-REAR-L WOOFER CENTER R-FRONT-L
IMPEDANCE