Samsung Q1B - Manual (Page 119)

Questions and Answers 119
If your network does not support DHCP, you have to manually configure an IP address by ask-
ing your network administrator.
In addition, even if your network supports DHCP, the Internet connection may not be available
if the DHCP server fails to allocate an IP address to your computer.
Q4 I have configured both wired and wireless connections with the same IP address,
but the network connections do not work properly.
A You cannot use the same IP address for wired and wireless connections. To use only one IP
address for both wired and wireless connections, you must disable one of them according to
your requirements in Network Connections in the Control Panel.
Q5 After installing the Wireless LAN Setting program, the "AEGIS Protocol (IEEE
802.1x)" protocol appears in the [Local Area Connect Properties] window.
A The protocol is a security authentication protocol that is automatically installed when the Wire-
less LAN Settings program is installed and does not affect the program operation.
Q6 I want to use the Wireless LAN power saving function to extend the system battery
use time.
A You can configure this in the Samsung Battery Manager program. Run the Samsung Battery
Manager and select Options > Wireless LAN Power Saving > On from the menu.
However, this setting may affect the performance of the Wireless LAN.
In addition, the wireless LAN connection might be disconnected while configuring this.