Siemens SL370 - Manual (Page 47)

46
Using several handsets
Gigaset SL375 / AUS / A31008-M1903-C401-1-7619 / registr_sett.fm / 14.8.07
Ve
rs
ion 4,
16
.09.
2005
You will hear the error tone (descending
tone sequence) if you assign an internal
number twice.
¤
Repeat the procedure with a free
number.
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously stored destination number is called
as soon as a set noise level is reached. You
can store an internal or external number
in your handset as the destination
number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx.
3 minutes (depending on the base sta-
tion). While the room monitor is activated,
all keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer tone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function remains
activated.
If you deactivate then reactivate the hand-
set, the room monitor mode remains acti-
vated.
Activating the room monitor and
entering the number to be called
v
¢
í
¢
Room Monitor
¤
Change multiple line input:
Room M.:
Select On to activate.
Call to:
External number:
Select the number from the directory
(press display key Ò ) or enter it
directly. Only the last 4 digits are dis-
played.
Internal number:
§Options§
¢
INT
¢
§OK§
¢
s (select
handset or Call All if all registered hand-
sets are to be called)
¢
§OK§ .
Level:
Set noise level sensitivity ( Low or High ).
¤
Press §Save§ to save the settings.
Caution!
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on the hand-
set's operating time is severely reduced.
If necessary, place the handset in the
charging cradle. This ensures that the bat-
teries do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answer machine.