Chapter 2:installation, Connecting vhf and uhf antennas, Antennas with 300-ohm flat twin leads – Samsung CL21M2 User Manual
Page 11
English - 11
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this,
see “Antennas with 300-ohm Flat Twin Leads”
below.
If your antenna has one lead that looks like this,
see “Antennas with 75-ohm Round Leads” on the
next page.
If you have two antennas, see “Separate VHF and
UHF Antennas” on the next page.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the screws
on the 300-75 ohm adaptor
(not supplied). Use a
screwdriver to tighten the
screws.
2
Plug the adaptor into the
“VHF/UHF” terminal on the
rear panel.
I
N S TA L L AT I O N
C h a p t e r Tw o
AA68-03671H-00Eng_Latin 1/9/06 9:20 AM Page 11