Samsung 5400 - Manual (Page 156)

156 Handbook
|
04 IMAGE IN MCF
When a message confirmation of a memory transmission is
printed, this function adds a portion of the first page of the
document that was sent. This feature makes it easier to
identify a fax, but it may present security problems if you
are sending sensitive documents.
Available settings are ON (default) and OFF.
05 SENDER ID
This function controls the printing of your fax machine’s
Sender ID on the faxes you send. Refer to the
“Programming Required Information, Fax Identification”
section of this handbook for details. When turned on, the
Sender ID will be printed on each page slightly outside
the image area of your document.
The default setting is ON.
! In order to meet FCC requirements, you must have this
feature set to ON and have a valid Sender ID
programmed in your fax machine.
06 MONITOR VOLUME
This function sets the volume for telephone line
monitoring during dialing.
Available settings are LOW (default), HIGH, and OFF.
07 BUZZER VOLUME
This function sets the volume of the various tones your
fax machine emits during operation. Available settings are
LOW, MIDDLE (default), and HIGH.
08 CLOSED NETWORK
This function allows you to program your fax machine to
refuse to communicate with locations whose telephone
numbers have not been programmed into your One Touch
keys or Auto Dial locations. Using this function, you can
set up a closed network of fax machines. Refer to the
“Security, Rejecting Unsolicited (Junk) Fax Messages”
section of this handbook. If you do not want your fax
machine to transmit faxes to or receive faxes from
locations outside your network, select T/R. If you only
want your fax machine to refuse to receive faxes from
outside your network, select RX.
Available settings are OFF (default), T/R, and RX.