Samsung 5400 User Manual

Page 159

Advertising
background image

|

Handbook

159

16 INCOMING RING

This function controls the telephone ringing sound your
fax machine makes when a call comes in. When set to off,
it does not ring during incoming calls. The available
settings are:
ON (default): Only rings when set to Manual Receive
[TEL] mode or when the RING RESPONSE function is set
to 5, 10, or 20 seconds.
OFF: Does not ring when a call comes in.
DRC (distinctive ring cancel): Rings for each incoming
call with the same tone, even if you have set function
setting 12, DISCTINCTIVE RING to on.

17 REMOTE RECEIVE

This function lets you use an attached phone to tell your
fax machine to switch from telephone to fax mode so it
can receive an incoming fax. Use the keypad of an
external telephone to enter the remote receive number you
have programmed into your fax machine.
In addition, if your fax machine is in TAD mode, a caller
can enter the programmed remote receive number after
leaving a voice message; this enables the fax machine to
receive a fax from the caller.

Refer to the “Answering Mode, Using Your Fax with an
Answering Machine [TAD]” section of this handbook.
Available settings are OFF (default), 00, 11, 22, 33, 44, 55,
66, 77, 88, 99, **, and ##.

18 MEM./FEEDER SW.

The fax unit is set to scan documents in and transmit them
from memory. This function controls how manual feed
transmissions are performed. Available settings are
FEEDER (the default setting) and MEMORY.

19 NOT USED

20 ECM FUNCTION

The error correction mode function may help your fax
machine improve communication in areas where
telephone line conditions are marginal. Refer to the
“Problem Solving” section of this handbook for other
suggestions if you have communication problems.
Available settings are ON (default) and OFF.

21 REMOTE DIAGNOSIS

The remote diagnostics feature allows a service person
remotely to dial and service your fax machine.
Available settings are ON and OFF (default).

Advertising