Samsung HT-AS730S - Manual (Page 46)


OptiOn SetUp (Continued)
DrC
You can use this function to enjoy Dolby Digital sound when
watching movies at low volume at night.DRC compresses the
audio to make the loudest sounds quieter and the quietest
sounds louder.
Each time you press ▲▼ button, DRC : STD  DRC : MIN 
DRC : MAX will be selected in turn.
Setting DrC
STD : Sets DRC effect to standard.
MAX : Sets DRC effect to maximum.
MIN : Sets DRC effect to minimum.
HDmi Setup
Use this if you want to transfer audio signal using the HDMI cable.
HDMI Audio : AVR, TV
This preference determines whether audio received at the HDMI IN is output by the HDMI OUT. You
may want to turn this preference on if your TV is connected to the HDMI OUT and you want to listen
to the audio from a component that’s connected to an HDMI IN, through your TV’s speakers.
Normally, this should be set to Off.
- AVR : HDMI audio is not output
- TV : HDMI audio is output
Anynet + Mode : Off, On
Anynet+ is a function that enables you to control other Samsung Devices with your Samsung TV's
remote control.
- On : Anynet + enabled.
- Off : Anynet - disabled.
AUTO LIPSYNC : ON, OFF
The AV receiver can be set to automatically correct any delay between the video and the audio,
based on the data from the connected monitor.
- ON : HDMI lip sync enabled.
- OFF : HDMI lip sync disabled.
HDMI Audio is enabled only if both of HDMI INPUT and HDMI OUT are connected properly and work normally.
To move up one level from SETUP/MENU or EXIT SETUP when the SETUP mode is released, press the RETURN
button.
This function works only if your HDMI-compatible TV supports HDMI Lip Sync.
~
~
~
~
1.
.
.
M
`
`
`


HT-AS730S-XAA_0204.indd 46 2009-02-05 �� 11:48:01