Smeg KIV90X - Manual (Page 10)

EN
2
1
21
USE
L T1 T2 T3 T4
L1 L2 L3 L4
Control panel
Button Function Led
L Press briefly to turn the lighting system on and off.
Press and hold for approx. 2 seconds to turn the lighting system
on and off at reduced intensity.
-
T1 Turn the suction motor on and off at speed one.
If the filter saturation alarm is on, this resets it.
On.
T2 Turn the suction motor on at speed two.
If the filter saturation alarm is on, this resets it.
On.
T3 Press once to turn the suction motor on and off at speed three.
Press again to activate intensive speed. This speed is timed to run
for 10 minutes. At the end of this time the system will
automatically return to the speed set before.
Suitable to deal with maximum levels of cooking fumes, it is de-
activated by pressing any one of the Speed buttons (T1-T2-T3).
It cannot be activated if the Delay function is in use.
If the filter saturation alarm is on, this resets it.
On.
Flashing.
T4 Activate automatic switch-off with a 30’ delay (Motor+Lights).
Suitable to complete elimination of residual odours.
Can be activated from any Speed, and is disabled by pressing the
button again or turning the motor off.
It cannot be activated if the Intensive function is in use.
If the filter saturation alarm is on, this resets it.
On.
Warning: The working hours of the motor are counted for the purpose of signalling filter
saturation.
After 100 working hours all the LEDs (L1-L2-L3-L4) will light up and remain lit to indicate
saturation of the metal grease filters.
After 200 working hours all the LEDs (L1-L2-L3-L4) will light up and start to flash to indicate
saturation of the activated charcoal filters.