Samsung 20051111115925328 - Manual (Page 68)

67
• If you are instaling the system for the first time, “ NO MEASURED DATA ” will appear on the display when you
press the ASC button while the ASC Microphone is not connected.
• During the Auto Sound Calibration setup, the speaker tone's output volume is fixed. You cannot use the volume
buttons to adjust the output level.
• If you remove the ASC Microphone during ASC setup, the setting will be cancelled.
Note
Auto Sound Calibration
By setting the ASC function just once, the speaker distance, channel level and rear sound reflection
effect are automatically set and create an optimal listening environment.
• This function works only in DVD/CD function.
• If you install the speaker as the RRSS speaker, make sure to install the rear speaker toward the side
wall so that rear speaker sounds of the front/rear speaker (left/right) are reflected against the wall.
1
Connect the ASC
Microphone to ASC
input connector.
2
Place the ASC
Microphone at the
listening position.
• A speaker tone will be output from
L
➝ R after signal sound is output
one time in the order of
L
➝ C ➝ R ➝ RS ➝ LS ➝ SW.
• An optimal listening environment
will be set up automatically
• It takes about 3~4 minutes to
complete the ASC setup.
Signal sound is output
Setting is complete after piano
sound is output.
3
Press the ASC
button.
4
When “ REMOVE
MIC ” appears on the
display, disconnect
the ASC microphone.
45P~88P(DS665T)-SECAGB 9/22/04 5:28 PM Page 68