Samsung HW-C450 - Manual (Page 12)

1
POWER TV POWER
VOL/CONTROL TV CH
AV SYNC DRC
MUTE
S.VOL
O/A INPUT S/W LEVEL
AUTO POWER
MENU
EXIT
TOOLS
INFO
SOUND MODE
DIMMER
POWER TV POWER
VOL/CONTROL TV CH
AV SYNC DRC
MUTE
S.VOL
O/A
INPUT
S/W
LEVEL
AUTO
POWER
MENU
EXIT
TOOLS
INFO
SOUND
MODE
DIMMER
cOnnEcTinG THE WiRElESS SUBWOOFER
The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly)
automatically when main unit is turned on. If the link indicator does not light when main unit and subwoofer are
turned on, please set the ID by following the process below.
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will come on after 30 seconds Link indicator(Blue LED)
blinking.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or
any other device that uses the same frequency (2.4GHz or 5.8GHz) near the system, some
sound interruption may be heard due to interference.
The transmission distance of the wireless signal between the main unit and sub is about 33 ft.,
but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because
the wireless signal cannot penetrate metal.
If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the
connection between the main unit and wireless subwoofer.
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
▪
▪
▪
▪
▪
▪
▪
1. Plug the power cords of the main unit and subwoofer into an AC power supply.
. Press the id SeT button on the back of the subwoofer with a small, pointed object for 5 seconds.
The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly. •
STANDBY
LINK
. While the main unit is powered off (STANDBY mode), press
MuTe on the remote control for 5 seconds.
. The Power Indicator on the main unit lights off and on, then
returns to STAndby mode.
The main unit and the subwoofer are now linked (connected).
The Link indicator (blue LED) on the subwoofer is turned on.
You can enjoy better sound from the wireless subwoofer by
selecting the sound field mode. ( See page 15 ) •
•
•