Sony CFD-S350L User Manual

Cd radio cassette- corder, Precautions, Specifications

Advertising
background image

©2005 Sony Corporation

Operating Instructions

CD Radio
Cassette-
Corder

2-548-052-13 (1)

CFD-S350
CFD-S350L

Precautions

On safety

• As the laser beam used in the CD player

section is harmful to the eyes, do not
attempt to disassemble the casing. Refer
servicing to qualified personnel only.

• Should any solid object or liquid fall into

the player, unplug the player, and have it
checked by qualified personnel before
operating it any further.

• Discs with non-standard shapes (e.g.,

heart, square, star) cannot be played on
this player. Attempting to do so may
damage the player. Do not use such discs.

Cleaning the cabinet

• Clean the cabinet, panel and controls with

a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol or benzine.

On power sources

• For AC operation, check that the player’s

operating voltage is identical with your
local power supply (see “Specifications”)
and use the supplied mains lead; do not
use any other type.

• The player is not disconnected from the

AC power source (mains) as long as it is
connected to the wall outlet, even if the
player itself has been turned off.

• For battery operation, use six R20 (size D)

batteries.

• When the batteries are not to be used,

remove them to avoid damage that can be
caused by battery leakage or corrosion.

• The nameplate indicating operating

voltage, power consumption, etc. is
located at the bottom.

On placement

• Do not leave the player in a location near

heat sources, or in a place subject to direct
sunlight, excessive dust or mechanical
shock.

• Do not place the player on an inclined or

unstable place.

• Do not place anything within 10 mm of

the side of the cabinet. The ventilation
holes must be unobstructed for the player
to operate properly and prolong the life of
its components.

• If the player is left in a car parked in the

sun, be sure to choose a location in the car
where the player will not be subjected to
the direct rays of the sun.

• Since a strong magnet is used for the

speakers, keep personal credit cards using
magnetic coding or spring-wound watches
away from the player to prevent possible
damage from the magnet.

On operation

• If the player is brought directly from a

cold to a warm location, or is placed in a
very damp room, moisture may condense
on the lenses inside the CD player section.
Should this occur, the player will not
operate properly. In this case, remove the
CD and wait about an hour for the
moisture to evaporate.

• If the player has not been used for a long

time, set it in the playback mode to warm
it up for a few minutes before inserting a
cassette.

Specifications

CD player section

System

Compact disc digital audio system

Laser diode properties

Material: GaAlAs
Wave length: 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a distance
of about 200 mm from the objective lens surface
on the optical pick-up block with 7 mm
aperture.)

Spindle speed

200 r/min (rpm) to 500 r/min (rpm)
(CLV)

Number of channels

2

Frequency response

20 - 20 000 Hz +1/–2 dB

Wow and flutter

Below measurable limit

Radio section

Frequency range

CFD-S350

FM

87.5 - 108 MHz

AM

531 - 1 611 kHz (9 kHz step)
530 - 1 610 kHz (10 kHz step)

CFD-S350L

FM

87.5 - 108 MHz

MW

531 - 1 611 kHz (9 kHz step)
530 - 1 610 kHz (10 kHz step)

LW

153 - 279 kHz

IF

FM: 10.7 MHz
AM/MW/LW: 450 kHz

Aerials

FM: Telescopic aerials
AM/MW/LW: Built-in ferrite bar aerials

Cassette-corder section

Recording system

4-track 2 channel stereo

Fast winding time

Approx. 120 s (sec.) with Sony cassette C-60

Frequency response

TYPE I (normal): 80 - 10 000 Hz

General

Speaker

Full range: 10 cm dia., 3.2

, cone type (2)

Outputs

Headphones jack (stereo minijack):
For 16 - 68

impedance headphones

Maximum Power output

5.2 W

Power requirements

For CD radio cassette-corder:
Malaysia, Singapore and Thailand models:
230 - 240 V AC, 50Hz
Korean model: 220 V AC, 60 Hz
Other models: 230 V AC, 50 Hz
9 V DC, 6 R20 (size D) batteries
For remote control:
3 V DC, 2 R03 (size AAA) batteries

Power consumption

AC 14 W

Battery life

For CD radio cassette-corder:

FM recording

Sony R20P: approx. 13.5 h

Sony alkaline LR20: approx. 20 h

Tape playback

Sony R20P: approx. 7.5 h

Sony alkaline LR20: approx. 15 h

CD playback

Sony R20P: approx. 2.5 h

Sony alkaline LR20: approx. 7 h

Troubleshooting

General

The power does not come on.

• Make sure the batteries are inserted correctly.
• Replace all the batteries with new ones if they

are weak.

• You cannot turn on the player with the remote

when you operate the player on batteries.

The power is not on, and “bAttErY”
and “Error” are displayed alternately.

• Make sure the batteries are inserted correctly.
• Replace all the batteries with new ones if they

are weak.

There is no audio.

• Adjust the volume.
• Unplug the headphones when listening

through speakers.

Noise is heard.

• Someone is using a portable telephone or

other equipment that emits radio waves near
the player.

tMove the portable telephone,

etc., away from the player.

CD Player

The CD does not play or “no dISC”
lights in the display even when a CD
is in place.

• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD

compartment open for about an hour to dry
moisture condensation.

• The CD-R/CD-RW was not finalized. Finalize

the CD-R/CD-RW with the recording device.

• There is a problem with the quality of the CD-

R/CD-RW, recording device or application
software.

• The CD-R/CD-RW is blank.
• Replace all the batteries with new ones if they

are weak.

The sound drops out.

• Reduce the volume.
• Clean the CD, or replace it if the CD is badly

damaged.

• Place the player in a location free from

vibration.

• Clean the lens with a commercially available

blower.

• The sound may drop out or noise may be

heard when using poor quality CD-Rs/CD-
RWs or if there is a problem with the
recording device or application software.

Radio

Reception is poor.

• Reorient the aerial to improve FM reception.

• Reorient the player itself to improve AM or

MW/LW reception.

The audio is weak or has poor quality.

• Replace all the batteries with new ones if they

are weak.

• Move the player away from the TV.

The picture of your TV becomes
unstable.

• If you are listening to an FM programme near

the TV with an indoor aerial, move the player
away from the TV.

Notes on cassettes

• Break off the cassette tab from side A or B

to prevent accidental recording. If you
want to reuse the tape for recording, cover
the broken tab with adhesive tape.

• The use of a cassette with more than 90

minutes of play time is not recommended
except for long, continuous recording or
playback.

Notes on CDs

• Before playing, clean the CD with a

cleaning cloth. Wipe the CD from the
center out.

• Do not use solvents such as benzine,

thinner, commercially available cleaners
or anti-static spray intended for vinyl LPs.

• Do not expose the CD to direct sunlight or

heat sources such as hot air ducts, nor
leave it in a car parked in direct sunlight as
there can be a considerable rise in
temperature inside the car.

• Do not stick paper or sticker on the CD,

nor scratch the surface of the CD.

• After playing, store the CD in its case.
If there is a scratch, dirt or fingerprints on the
CD, it may cause tracking error.

About CD-Rs/CD-RWs

This player can play CD-Rs/CD-RWs
recorded in the CD-DA format*, but
playback capability may vary depending on
the quality of the disc and the condition of
the recording device.

* CD-DA is the abbreviation for Compact

Disc Digital Audio. It is a recording
standard used for Audio CDs.

Music discs encoded with copyright
protection technologies

This product is designed to play back discs
that conform to the Compact Disc (CD)
standard. Recently, various music discs
encoded with copyright protection
technologies are marketed by some record
companies. Please be aware that among
those discs, there are some that do not
conform to the CD standard and may not be
playable by this product.

If you have any questions or problems
concerning your player, please consult your
nearest Sony dealer.

Tape Player

The tape does not move when you
press an operation button.

• Close the cassette compartment securely.

The

z

button does not function or the

tape does not play or record.

• Make sure the safety tab on the cassette is in

place.

Poor or distorted playback, recording
or erasing quality.

• Clean the heads, pinch roller and capstan with

a cleaning swab slightly moistened with
cleaning fluid or alcohol.

• Replace all the batteries with new ones if they

are weak.

• TYPE II (high position) or TYPE IV (metal)

tape is being used. Use TYPE I (normal) tape
only.

• Demagnetize the heads using a commercially

available tape head demagnetizer.

Remote

The remote does not function.

• Replace all the batteries in the remote with

new ones if they are weak.

• Make sure that you are pointing the remote at

the remote sensor on the player.

• Remove any obstacles in the path of the

remote and the player.

• Make sure the remote sensor is not exposed to

strong light such as direct sunlight or
fluorescent lamp light.

• Move closer to the player when using the

remote.

After trying the above remedies, if you still have
problems, unplug the mains lead and remove all
the batteries. After all the indications in the
display disappear, plug the mains lead and insert
the batteries again. If the problem persists,
please consult your nearest Sony dealer.

Erase head

Pinch roller

Record/playback head

Lens

Tab for side B

Connect the mains lead A or insert six R20 (size D) batteries (not supplied) into the battery
compartment B .

Notes

• Replace the batteries when the OPR/BATT indicator dims or when the player stops operating.

Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD
from the player.

• To use the player on batteries, disconnect the mains lead from the player.
• When you operate the player on batteries, you cannot turn on the player using the remote.

Preparing the remote C

Insert two R03 (size AAA) batteries (not supplied).

Replacing batteries

With normal use, the batteries should last for about six months. When the remote no longer
operates the player, replace all the batteries with new ones.

Power Sources

Tab for side A

1

to AC IN

2

to the mains

A

C

Side A

Capstan

Dimensions

Approx. 420

Ч

155

Ч

260 mm (w/h/d)

(16

5

8

Ч

6

1

8

Ч

10

1

4

inches)

(incl. projecting

parts)

Mass

Approx. 3.7 kg (8 lb. 3 oz) (incl. batteries)

Supplied accessory

Mains lead (1)
Remote control (1)

Design and specifications are subject to change
without notice.

Optional accessories

Sony MDR headphone series

English

WARNING

To prevent fire or shock hazard, do
not expose the player to rain or
moisture.

To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.

WARNING

Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.

To prevent fire or shock hazard, do not place
objects filled with liquids, such as vases, on the
appliance.

Connect the apparatus to an easily accessible
AC outlet. Should you notice an abnormality in
the apparatus, disconnect the main plug from the
AC outlet immediately.

Notice for customers in the United
Kingdom

A moulded plug complying with BS 1363 is
fitted to this equipment for your safety and
convenience.

Should the fuse in the plug supplied need to be
replaced, same rating fuse approved by ASTA or

BSI to BS 1362, (i.e. marked with

or

mark) must be used.

If the plug supplied with this equipment has a
detachable fuse cover, be sure to attach the fuse
cover after you change the fuse. Never use the
plug without the fuse cover. If you should lose
the fuse cover, please contact your nearest Sony
service station.

B

Advertising
This manual is related to the following products: