Solo USA MISTBLOWER 444 - Manual (Page 15)

Operating Hints
ENGLISH 15
Should the actual value be too high, the metering body
may be worn or damaged. In that case, replace the
metering body with a new one (part no.:40 74 165).
When using accessory sets (liquid pump part no.:
type 444 Î 44 00 114, type 450 Î 44 00 235 or ULV
accessory, part no.: 49 00 479) a strainer will be
integrated into the tank connector.
In that case, an incorrect flow rate can also be due to a
contaminated or worn strainer.
Clean or replace the contaminated/worn strainer (part
no.: 25 00 198).
7.7 Draining and cleaning the tank
For cleaning purposes, the tank can be fully drained
into a suitable container via the supply hose.
For this, the engine must be cooled down.
Position the equipment onto a stable higher support, so
that the spray medium can drain into a suitable
container below.
Above the container, pull the supply hose from the
shut-off valve.
If required, tip the equipment slightly to drain the tank
completely.
Ensure that the spray medium does not run over the
equipment (especially the engine), but drains directly
into the suitable container.
Dispose of residual spray medium correctly at disposal
sites licensed for specialised waste.
Empty the spray medium tank daily after work and flush
thoroughly with water.
Observe cleaning instructions supplied with the
herbicide/fungicide.
After cleaning, let the spray medium container dry in an
open state.
Occasionally clean the strainer inside the filler neck,
the strainer in the accessory set and all parts in contact
with the medium, with water and a soft brush.
7.8 Application
According to its type designation, this equipment is
suitable for:
• Agriculture,
• horticulture,
• orchards,
• green spaces,
• vineyards,
• nurseries;
Fig. 12
Fig. 13