Sony RM-LJ302 - Manual (Page 17)

17
Using the Lists
Performing Several
Commands in Sequence
Automatically (Macro Play)
The Macro Play function lets you link several IR codes in
a sequential order as a single command. The remote
provides 2 macro lists (MACRO 1 and 2). You can specify
up to 8 IR codes for each macro list.
Setting the sequence of IR codes
1
Press SET UP.
The set up list appears.
IR SET
DOWNLOAD
AUTO POWER
2
Move the easy scroll key to select “IR SET,” then
press the key to enter the selection.
The IR SET list appears.
<IR SET>
[ MACRO1 ]
[ MACRO2 ]
3
Move the easy scroll key to select “MACRO 1” (or
“MACRO 2”), then press the key to enter the
selection.
The PROGRAM list appears.
Program No.?
Macro 1-1
Macro 1-2
4
Move the easy scroll key to select the macro step
number (“Macro 1-1” for example) then press the
key to enter the selection.
The CATEGORY list appears.
CATEGORY?
VTR
TV
5 Move the easy scroll key to select the component
category (“VTR” for example) then press the key to
enter the selection.
The MAKER list appears.
MAKER?
Sony VTR1
Sony VTR2
6
Move the easy scroll key to select the maker, then
press the key to enter the selection.
The FUNCTION list appears.
FUNCTION?
NO SET
WAIT TIME
7 Move the easy scroll key to select the IR code for
the operation you want to perform, then press the
key to enter the selection.
The PROGRAM list reappears.
Program No.?
Macro 1-1
Macro 1-2
8 Repeat steps 4 through 7 to program up to 8 IR
codes.
When you have finished programming IR codes
Select “EXIT” in step 7.
To cancel programming
Move the easy scroll key to select “EXIT” or “CANCEL”
during any step, then press the key to enter the selection.
To erase a programmed IR code
Move the easy scroll key to select “NO SET” from the
FUNCTION list, then press the key to enter the selection.
To turn off all connected components
Move the easy scroll key to select “ALL OFF” from the
FUNCTION list, then press the key to enter the selection.
To delay the output of an IR code
Move the easy scroll key to select “WAIT TIME” from the
FUNCTION list, then press the key to enter the selection.
This allows you to specify a 1 to 10 second delay (in 1
second increments) before outputting the IR code.