Simplicity 1692969 - Manual (Page 20)

SERVICING THE MOWER BLADES
A WARNING
For your personal safety, do not handle the
sharp mower blades with bare hands. Careless
or improper handling of blades may result in
serious injury.
For your personal safety, blade mounting
screws must each be installed with a hex washer
and spring washer, then securely tightened.
Torque blade mounting
to 50 70
ft. Ibs. (67 95
1. Remove mower from the tractor. Sea Mower
Installation Removal.
2. Blades should be sharp and free of nicks and dents.
If not, sharpen blades as described in following steps.
3. To remove blade for sharpening, use wooden block
to hold blade while removing the blade mounting
screw (figure 14).
4. Use a file to sharpen blade to fine edge. Remove all
nicks and dents in blade edge. If blade is severely
damaged, it should be replaced.
5. Balance the blade as shown in figure 15. Center the
blades’ hole on a nail lubricated with a drop of oil. A
balanced blade will remain level.
Figure 14. Removing the Blade
- W o r k b e n c h
6. Reinstall each blade with the tabs pointing up toward
deck as shown in figure 16. Secure with a capscrew,
spring washer and hex washer. Use a wooden block
to prevent blade rotation and torque capscrews to 50-
70
(67-95 N.m.).
A
WARNING
Figure 15. Balancing The Blade
Figure 16. Installing The Blade
1 6