4 drive mounting, Drive mounting, Figure 3 – Seagate BARRACUDA GREEN ST2000DL003 User Manual
Page 24: Attaching sata cabling
24
Barracuda Green SATA Product Manual, Rev. B
Configuring and Mounting the Drive
Figure 3 Attaching SATA cabling
Each cable is keyed to ensure correct orientation. Barracuda LP drives support latching SATA connectors.
3.4
Drive mounting
You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom-mounting holes. See
for drive mounting dimensions. Follow these important mounting
precautions when mounting the drive:
• Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.150 in (3.81mm) into the bottom or side mounting holes.
Do not overtighten the mounting screws (maximum torque: 6 in per lb).
Power cable
Signal cable
Signal connector
Power connector