SRS Labs SR850 - Manual (Page 205)

6-29
Remote Programming
STATUS REPORTING COMMANDS
The Status Byte definitions follow this section.
❊ CLS The ❊ CLS command clears all status registers. The status enable regis-
ters are NOT cleared.
❊ ESE (?) {i} {,j} The ❊ ESE i command sets the standard event enable register to the
decimal value i (0-255). The ❊ ESE i,j command sets bit i (0-7) to j (0 or
1). The ❊ ESE? command queries the value (0-255) of the status byte
enable register. The ❊ ESE? i command queries the value (0 or 1) of bit i.
❊ ESR? {i} The ❊ ESR? command queries the value of the standard event status
byte. The value is returned as a decimal number from 0 to 255. The
❊ ESR? i command queries the value (0 or 1) of bit i (0-7). Reading the
entire byte will clear it while reading bit i will clear just bit i.
❊ SRE (?) {i} {,j} The ❊ SRE i command sets the serial poll enable register to the deci-
mal value i (0-255). The ❊ SRE i,j command sets bit i (0-7) to j (0 or
1).The ❊ SRE? command queries the value (0-255) of the serial poll
enable register. The ❊ SRE? i command queries the value (0 or 1) of bit i.
❊ STB? {i} The ❊ STB? command queries the value of the serial poll status byte.
The value is returned as a decimal number from 0 to 255. The ❊ STB? i
command queries the value (0 or 1) of bit i (0-7). Reading this byte has
no effect on its value.
❊ PSC (?) {i} The ❊ PSC command sets the value of the power-on status clear bit. If
i=1 the power-on status clear bit is set and all status registers and enable
registers are cleared on power up. If i=0 the bit is cleared and the status
enable registers maintain their values at power down. This allows a ser-
vice request to be generated at power up.
ERRE (?) {i} {,j} The ERRE i command sets the error status enable register to the deci-
mal value i (0-255). The ERRE i,j command sets bit i (0-7) to j (0 or 1).
The ERRE? command queries the value (0-255) of the error status
enable register. The ERRE? i command queries the value (0 or 1) of bit i.
ERRS? {i} The ERRS? command queries the value of the error status byte. The
value is returned as a decimal number from 0 to 255. The ERRS? i com-
mand queries the value (0 or 1) of bit i (0-7). Reading the entire byte will
clear it while reading bit i will clear just bit i.
LIAE (?) {i} {,j} The LIAE command sets the lock-in (LIA) status enable register to the
decimal value i (0-255). The LIAE i,j command sets bit i (0-7) to j (0 or 1).
The LIAE? command queries the value of the LIA status enable register.
The LIAE? i command queries the value (0 or 1) of bit i.
LIAS? {i} The LIAS? command queries the value of the lock-in (LIA) status byte.
The value is returned as a decimal number from 0 to 255. The LIAS? i
command queries the value (0 or 1) of bit i (0-7). Reading the entire byte
will clear it while reading bit i will clear just bit i.