Sharp UX-340L - Manual (Page 69)

Sending a Fax by Automatic Dialing
67
3. Sending D
o
c
u
ments
Direct Keypad Dialing
You can also enter a full number with the number keys and then press
the START/MEMORY key to begin dialing. You can use this method
to dial a full number when you don’t need to speak to the other party
before faxing.
1
Load the document(s).
The display will show:
READY TO SEND
•
Set the resolution and/or contrast if
desired.
2
Enter the number of the receiving
machine by pressing the numeric
keys.
•
If a pause is required between any
of the digits to access a special
service or an outside line, press the
REDIAL
key (two seconds per
pause). The pause will appear as a
hyphen. Several pauses can be
entered in a row.
3 2 2 4 5 6 7
3
Check the display. If the number of
the receiving machine shown is
correct, press the START /
MEMORY
key.
•
If it is not correct, press the STOP
key to backspace and clear one
digit at a time, and then re-enter the
correct digit(s).
(Example)
RESOLUTION
START/MEMORY
all-ux340L.book Page 67 Thursday, December 23, 1999 5:37 PM