Sony BDV-T20W - Manual (Page 18)

18 US
Gettin
g
Star
ted
Caution
• Contact a screw shop or installer regarding the wall material or screws to be used.
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
Before installing the front speakers of BDV-E500W on a wall, you need to disassemble the speakers.
You can install the upper part of a speaker on a wall.
To disassemble the speaker
(Front speakers of BDV-E500W only)
1
Disconnect the speaker cords from the speaker.
2
Remove the screw (pre-installed) at the rear of the speaker.
This screw is used when reassembling the speaker. Be sure not to lose the screw.
Installing the speakers on a wall
Rear of the speaker
Rear of the speaker
Screw