Step 3: setting up the wireless system, Step 3: setting up the wireless, System – Sony BDV-T20W User Manual
Page 32: Es 32, E 32), Gettin g star ted, The system turns on, Set the s-air id switch of the unit to a, Press " / 1, Press power on the surround amplifier
32
US
Gettin
g
Star
ted
Step 3: Setting up the
Wireless System
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transceivers are inserted
into the unit and the surround amplifier correctly
(page 28).
This wireless system is called “S-AIR.” For
details of the S-AIR function, see “Using an
S-AIR Product” (page 61).
The unit transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following Steps.
1
Set the S-AIR ID switch of the unit to A.
2
Press "/1.
The system turns on.
3
Set the SURROUND SELECTOR switch
of the surround amplifier to
SURROUND.
4
Set the S-AIR ID switch of the surround
amplifier to A.
5
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If it doesn’t, check the transmission
status as follows.
To check the transmission status
You can check the status of sound transmission
between the unit and surround amplifier by
observing the POWER / ON LINE indicator of
the surround amplifier.
For details of the surround amplifier, see
“Surround amplifier operation” (page 99).
To enjoy sound by using
headphones
You can enjoy the system’s sound by connecting
the headphones to the PHONES jack on the
surround amplifier.
Note
• The volume of the unit may become minimum if you
turn off the surround amplifier while the headphones
are connected to the surround amplifier, or radio
reception is poor. In this case, “HP NO LINK” and
“VOLUME MIN” appear alternately in the front
panel display. Check radio reception, and set the
volume again.
• When you connect the headphones to the surround
amplifier, sound is not output from the system’s
speakers.
ANTENNA
AUDIO
DIGITAL IN
DMPORT
HDMI OUT
COMPONENT VIDEO OUT
VIDEO OUT
S-AIR ID
AUDIO IN
AUDIO IN
A. CAL MIC
ECM-AC2
SPEAKER
Y
P
B
/ C
B
P
R
/ C
R
FM
AM
COAXIAL 75
COAXIAL
OPTICAL
R
L
R
L
FRONT R
FRONT L
CENTER
SUBWOOFER
EXT
LAN(100)
DC5V
700mA MAX
EZW-RT10
TV
TV
DIGITAL IN
SAT/CABLE
A
B
C
DC5V
500mA MAX
SPEAKER
S-AIR ID switch
3
2
1
6
5
4
9
8
7
0
"/1
POWER
POWER/ON LINE
PHONES
R
SURROUND SELECTOR
S-AIR ID
EZW-RT
10
SPEAKER
SURROUND
PAIRING
C
B
A
SURROUND
BACK
L
POWER
POWER / ON LINE
Indicator
SURROUND
SELECTOR switch
S-AIR ID switch
PHONES jack
POWER / ON LINE
indicator
Status
Turns green.
Sound transmission is
established.
Flashes green.
Sound transmission is not
established.
Turns red.
The surround amplifier does
not output sound.
Turns off.
The surround amplifier turns
off or its protection is active.