Setting up the channel list, Using initial setup – Sony KD-30XS955 User Manual
Page 44
43
SETU
P
Set
up
S
E
TU
P
SETU
P
S
E
TU
P
SETU
P
Setting Up the Channel List
After you finish connecting the TV, you need to run the Initial Setup
feature, which automatically creates a list of available analog and
digital channels and lets you correct tilt and vertical correction
settings. The Initial Setup screens appear when you turn on your TV
for the first time after hooking it up.
Using Initial Setup
To run Initial Setup
1
Press
POWER
to turn on the TV.
The Initial Setup screen appears.
Using the remote control, move the highlight to the desired
language, then press
to select that language. The Tilt
Correction screen appears.
2
Press
B
b
to correct any tilt of the picture. You can choose a
correction between +7 and -7. When finished, press
.
3
The Vertical Correction screen appears. Press
V
v
to make a vertical correction to the picture. You can choose a
correction between +5 and -5. When finished, press
.
4
The next screen instructs you to connect your cable/antenna.
Check that you’ve connected your signal source correctly.
To start Auto Program, highlight
Yes
and then press
.
Auto Program automatically creates a list of receivable analog
and digital channels. Auto Program may take 50 minutes or more
to complete. A progress bar is displayed while the channel list is
being created.
When Auto Program is finished, the lowest numbered channel is
displayed.
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on page 84.
To add individual digital channels
Use the Digital Channel feature as described on page 84.
To reset the TV to factory settings
1
Press
POWER
to turn on the TV.
2
Hold down
RESET
on the remote control.
3
Press
TV POWER
on the TV. (The TV will turn itself off, then back
on.)
4
Release
RESET
.
For more details on using
Tilt Correction and Vertical
Correction, see pages 89-90.
z
KD-30/34XS955 Only
To exit the Tilt Correction
and Vertical Correction screens,
press the
MENU
button.
z
If you are using a
CableCARD, Auto Program is
disabled for the CABLE input.
z
XS.book Page 43 Tuesday, June 8, 2004 1:40 PM