Sony KD-30XS955 - Manual (Page 50)

49
SETU
P
SETU
P
S
E
TU
P
Rem
o
te
Con
tr
ol
S
E
TU
P
SETU
P
Programming the Remote Control
If you have video equipment other than Sony brand (or if you have a
Sony DVD/VCR combination unit) that you want to control with the
TV’s remote control, use the following procedure to program the
remote control.
1 Turn to the list of “Manufacturer’s Codes” on page 50, and find
the three-digit code number for the manufacturer of your
equipment. (If more than one code number is listed, use the
number listed first.)
2 Press CODE SET.
3 Press the VCR/DVD FUNCTION or SAT/CABLE FUNCTION button.
4 Using the 0 - 9 buttons, enter the three-digit manufacturer’s code
number.
5 Press the ENTER button.
6 To check if the code number works, aim the TV’s remote control
at the equipment and press the
POWER button that corresponds
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
Notes ❑ If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
❑ If you enter a new code number, the code number you previously
entered at that setting is erased.
❑ In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment’s own remote control.
❑ Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be
reprogrammed.
✍
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 2 through 5.
XS.book Page 49 Tuesday, June 8, 2004 1:40 PM