Samsung ML-1250 - Manual (Page 125)

A
PPENDIX
A.26
Printing from DOS Applications
CONFIG
• Power Save determines the length of time the printer waits
after a job is printed before it goes to a reduced power state.
If the printer is used frequently, select OFF which keeps the
printer ready to print with the minimum warm-up time. This
uses more electricity to keep the printer warm and ready to
print.
• Econo Mode determines the toner quantity the printer
should use when printing. If set to ON, the printer conserves
toner when printing. The default value is OFF, which
provides 100% usage.
• Auto Continue determines what action the printer should
take when a manual feed print job is sent to the printer and
there is no paper in the Manual input tray. If set to ON, the
printer will pick up the paper from the Automatic input tray
after fifteen seconds. Otherwise, the printer will wait for you
to load paper in the Manual Tray.
• Jam Recovery determines what action the printer should
take when a paper jam occurs. When set to OFF, the printer
does not reprint a page that has jammed. When set to ON,
the printer keeps the image in memory for a printed page
until the printer signals that the page has successfully
printed. The printer reprints all jammed pages.
• Altitude With this option checked, you can optimize the print
quality for a low pressure area, such as a high ground.
JOB
• Timeout determines the amount of time (in seconds) the
printer will wait before printing the last page of a print job
that does not end with a command to print the page or a
formfeed character. Valid range is 0 to 300 seconds.
• Paper Type provides the printer with information about the
type of paper to be used for a print job. For the best result,
set this to the paper type you loaded in the paper tray in the
printer. When using the plain paper, set this to Plain paper.
• SRT Mode makes the printer optimize the print quality to
1200 dpi class image quality.