Sony PCM-R700 - Manual (Page 28)

3-859-278-11(1)
Operations Using the Optional Remote
27 EN
Writing and Erasing an End ID
Writing an end ID during recording
1
When the recording of the program source comes
to an end, press
P, R, or FADER.
Recording is paused.
2 Press END ID WRITE.
“ID WRITE” or “EE” appears in the display while
the end ID is being written.
When writing has finished, the record pause
mode is canceled and the deck rewinds the tape to
the beginning of the end ID.
To write an end ID during playback
Press END ID WRITE.
More accurate positioning of the end ID
1
During playback, press END ID REHEARSAL.
“REHRSL” appears in the display, and the
Rehearsal function repeatedly plays back a 3-
second portion that ends at the point where you
pressed the button. The repeated portion plays
back 8 times, and the deck stops.
2 Press 0 or ) to shift the position of the
beginning of the repeated portion.
Each time you press
0 or ), the beginning of
the repeated portion shifts backwards or forwards
by 0.3-second, up to a maximum extent of about 2
seconds (4 seconds in long-play mode) in either
direction.
The display shows the amount the starting
position has shifted from the time the END ID
REHEARSAL button was pressed.
3 After repositioning the beginning of the end ID,
press END ID WRITE.
“ID WRITE” appears for a few seconds and the
end ID is written on the tape after a duration of
about 9 seconds after the end of the the repeated
portion.
Erasing the end ID
Press END ID ERASE.
“(ERASE)” appears in the display while the deck fast-
forwards to the beginning of the end ID, then “ID
ERASE” appears while the deck erases the end ID. It
takes about 9 seconds (18 seconds in long-play mode)
to erase an end ID.
z You can use the End Search function to locate the
end ID
See page 14.
END ID
WRITE
END ID
REHEARSAL
FADER
END ID
ERASE
0/)
R
P
3
6
9
WRITE
WRITE
2
5
8
0
RENUMBER START ID
PRESENT
SKIP
PLAY REHEARSAL SKIP ID ERASE WRITE
1
4
7
AUTO
OPEN/
CLOSE
REHEARSAL
MODE
REHEARSAL
FADER INPUT MONITOR
ERASE
RESET
ERASE RECORDED
M.SCAN REPEAT MARGIN RESET CLEAR
0
= r
·
)
+ R
P p
END ID
CHECK ENTER
LOCATE MARK
RMS
COUNTER
DATE
AMS
6