Unpacking, Rack mounting, Getting started – Sony PCM-R700 User Manual

Page 5: Inserting batteries into the remote

Advertising
background image

Getting Started

3-

859

-

278

-12(1)

4

EN

Getting Started

Unpacking

Check that you have received the following supplied
items:
• AC power cord (1)
• Remote commander (remote) RM-D757 (1)
• Size-AA (R6) batteries (2)
• Screws (M5

×

12) (4)

• Decorative washers (4)
• Operating instructions (1)

Inserting batteries into the remote

Insert two size-AA(R6) batteries, matching the + and –
on the batteries with the markings inside the battery
compartment.

Rack Mounting

You can install your deck in a 19-inch 3U-size rack. Be
sure to disconnect the deck from the wall outlet before
you install it.

1

Remove the four feet from the deck.

Screw (M3

×

10)

2

Insert the deck into the rack and secure it with the
supplied decorative washers and screws (M5

×

12).

Rack

Decorative washer

Screw (M5

×

12)

Note

Do not reattach the screws directly after removing the four
feet. Put the screws and the feet in a safe place for
reattachment in the future. Using longer or shorter screws
may damage the internal circuit board.

OFF

WIRED

WIRELESS

REMOTE

z

When to replace the batteries

With normal use, batteries should last for about 6
months. When the remote no longer operates the deck,
replace both batteries.

Notes

• Do not leave the remote near an extremely hot or humid

place.

• Do not drop any foreign matter into the remote casing,

particularly when replacing the batteries.

• Do not expose the remote sensor to direct sunlight or

illumination as doing so may cause malfunction.

• When not using the remote for an extended period of time,

remove the batteries to avoid possible damage from
battery leakage and corrosion.

Before using the remote

Set REMOTE on the front panel to WIRELESS.

Advertising
This manual is related to the following products: