Sharp AR-M355N - Manual (Page 356)

PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES
6-13
6
SETTING FOR F-CODE RELAY BROADCAST MEMORY
BOXES (RECIPIENT)
Program the end receiving machines to which document data received in the F-code relay broadcast memory box
will be transmitted when your machine is a relay machine.
Up to 30 end receiving machines can be programmed. If you attempt to program more than this number, a message
will appear and programming will not be possible.
1 Touch the [RELAY BROADCAST] key in
step 3 of "PROGRAMMING AN F-CODE
MEMORY BOX" on pages 6-10 to 6-11 and
store a box name, sub-address, and
passcode.
2 Touch the [RECIPIENT] key.
The address selection
screen appears.
3 Touch the one-touch keys you wish to
include as end receiving machines.
Touch indexes and the
keys as
needed.
● The selected one-touch keys are highlighted and
programmed as end receiving machines.
● If you touch an incorrect key, touch the key again to
remove the highlighting and delete the destination.
● You can also use the [ ] key (speed dial key)
to store a one-touch key. (See "SENDING A FAX
BY SPEED DIALING" on page 2-4.)
● To enter a fax number that has not been stored in
a one-touch key, to enter a full fax number with the
numeric keys, touch the [DIRECT ENTRY] key and
then the [FAX] key and enter the fax number.
● Enter the fax number and then a sub-address and
transmission settings (if desired) as explained in
steps 10 to 13 and 15 of "STORING ONE-TOUCH
DIAL KEYS" on pages 6-3 to 6-4, and then touch
the [OK] key twice to return to the screen of step 3.
4 To check the destinations that have been
selected as end receiving machines,
touch the [ADDRESS REVIEW] key.
The destinations
selected as end
receiving machines are
displayed.
You can delete a
destination by touching
it. When the
confirmation message appears, touch the [YES]
key to delete the destination.
5 Touch the [OK] key in the screen of step 3.
You will return to the screen of step 2 and the
number of stored as end receiving machines will
appear.
6 To exit, touch the [EXIT] key. To program
another memory box, touch the [NEXT] key.
Touching the [EXIT] key returns you to the screen
of step 3 on page 6-10.
Touching the [NEXT] key returns you to the screen
for programming a new memory box (the screen of
step 4 on page 6-10).
SUB ADDRESS
BOX NAME FAX INFORMATION
123456/987654
RECIPIENT
1/1 A B
F-CODE MEMORY BOX / RELAY BROADCAST
SELECT ADDRESS.
DANIEL ERNY
FREQUENT USE ABCD EFGHI JKLMN OPQRST UVWXYZ
* 2
OK
DIRECT ENTRY
ADDRESS REVIEW
ABC GROUP
C GROUP CLIFF QUIROGA
JKLMN OPQRST UVWXYZ
OK
DIRECT ENTRY
ADDRESS REVIEW
GROUP ABC
FAX
E-MAIL
INTERNET-FAX
OPQRST UVWXYZ ABC GROUP
ADDRESS REVIEW
DIRECT ENTRY
OK
1/2
* 0
Tiger2_fax_sec.book 13 ページ ２００４年９月１６日 木曜日 午前８時５３分