Sharp AR-M355N - Manual (Page 368)

KEY OPERATOR PROGRAMS
8-5
8
Scan complete sound setting
You can select whether or not a beep sound is
made after an original is scanned on the scanner
unit.
Normally a beep sound is made.
You can select "High" or "Low" for the volume of
the beep.
Default exposure settings
This program is used to set the default exposure
level for scanning originals in fax / image send
mode, and for scan save in document filing mode*.
This program is initially set to "AUTO". If changed
to "MANUAL", the exposure level can be adjusted
to five levels. Level 1 is the lightest level and level
5 is the darkest level.
* Can only be used on the AR-M355N/AR-M455N.
The AR-M355U/AR-M455U models do not have
this function.
FAX SETTINGS
■ ■ ■ ■ Fax default settings
The default fax settings can be changed as necessary
to meet your faxing needs.
The "Fax default settings" are as follows:
● Fax own number and name set
● Dial mode setting (Setting your line type)
● Auto wake up print
● Pause time setting
● Speaker volume settings
● Original print on transaction report
● Remote reception number setting (only when
extension phone is connected)
● Transaction report print select setting
● Activity report print select setting
● ECM (This setting is only effective if the other
machine is a G3 machine that supports ECM)
● Distinctive ring detection
● Disable of fax number direct entry
Fax own number and name set
Use this setting to enter the fax number of the
machine and the name of the user. The entered
name and number are printed at the top of each fax
page you send. The number is also used as a
passcode when performing polling reception (see
"USING THE POLLING FUNCTION" on page 3-
14).
1 Touch the [NAME] key and enter the name.
The name entry screen appears.
Up to 20 characters can be entered for the name.
For information on entering characters, see
chapter 7 of the "Operation Manual (for general
information and copier operation)".
2 Touch the [FAX No.] key and enter the fax
number.
Enter up to 20 digits for the number using the
numeric keys.
To enter a "+", press the " " key.
To enter a hyphen, touch the [PAUSE] key. To
enter a space, touch the [SPACE] key.
If you make a mistake, press the [C] key and re-
enter the correct digit.
3 Touch the [OK] key.
You will return to the OWN NUMBER AND NAME
SET screen. The number you entered appears.
Make sure it is correct.
Dial mode setting
(Setting your line type)
Select the appropriate setting for your line type.
"Tone" is normally selected.
It is also possible to have the machine
automatically select the line type. Make sure that
the telephone line is connected to the machine,
and then touch the [AUTO SELECT] key at the
lower right. The machine will automatically select
"Tone" for a tone dial line, or "Pulse" for a pulse dial
line.
Auto wake up print
Use this setting to select how the machine
responds if a fax is received when the power switch
is turned off (the fax power switch is turned on).
Auto wake up print is normally turned on, which
means that the machine automatically activates
and prints the received fax. If you turn off this
setting, received faxes will not be printed until the
power switch is turned on.
NOTE
If a hyphen is entered, it will be changed to a space
at the time of transmission.
Tiger2_fax_sec.book 5 ページ ２００４年９月１６日 木曜日 午前８時５３分