Sony DSR-DR1000A - Manual (Page 26)

26
Setting the Time Data
C
h
ap
te
r 2
Pr
ep
ar
a
tio
ns
F Recording indications during
simultaneous playback and recording*
* Displayed only during simultaneous recording and playback mode (when
the R button or P button in the PANEL SELECT section is lit, or when the
REMOTE I/F menu item (see page 69) is set to 9PIN(DUAL).
To display the desired time data in the time
counter display
Press the COUNTER SELECT button on the front panel.
Each press of this button cycles through three options:
CNT value, time code, and user bit data. The time data type
indicator for each option lights as it is selected.
Note
When the REMOTE indicator in the front panel display
section is lit, the COUNTER SELECT button does not
operate during recording or playback. In such cases, use
the external equipment connected to the REMOTE IN (R)/
OUT (P) connector on the rear panel to select the time data.
To reset the CNT value
Press the RESET button in the menu control section. This
resets the CNT value to 0:00:00:00.
Using the Internal Time Code
Generator
You can set the initial time code value before recording the
time code generated by the internal time code generator
onto a disk. In addition, you can use the user bits to record
such data as the date, time, scene number, or other useful
information.
When an external time code generator is connected to the
TIME CODE IN connector, the internal time code
generator can be locked to (synchronized with) an external
time code.
REC-PAUSE Temporary stop of recording
REC LOCK Record mode (servo locked)
JOG STILL Still picture in jog mode
JOG FWD Jog mode in forward direction
JOG REV Jog mode in reverse direction
SHUTTLE (Speed) Shuttle mode
VAR (Speed) Variable mode
PLAY (Deviation from
normal speed (%)) Tape speed override (TSO) mode
(blank) Indicates that recording is not being
done.
(white rectangle) Indicates that recording is being
done.
Display Operation mode
COUNTER SELECT button
Time data type indicators
Time counter display
Time data
type
indicator Time data shown in the time counter
display
COUNTER CNT (count value of the time counter)
TC Time code (when recording, the time code is
generated by the internal time code
generator; when playing back, the time code
is read from the disk.)
U-BIT User bit data (when recording, the user bit
data is according to the most recent settings;
when playing back, the user bit data is read
from the disk.)