Sony DSR-DR1000A - Manual (Page 52)

52
Sending Data
Ch
ap
te
r 5 Net
w
o
rk Op
er
a
tio
ns
Sending Data
You can send each clip, clips registered in cliplists, and
address book data to other recorders.
Sending Clip Data
Use the following procedure to send clip data.
1
Select the SEND CLIP item in the Network menu and
press the
k (OUT) button.
The SEND CLIP screen appears, showing the currently
selected destination host name, the transfer target clip, and
its duration.
2
If the destination host and clip are correct, proceed to
step 8.
To change the destination host, select HOST and
press the
k (OUT) button.
A list of host registered in the address book appears.
If the destination that you want is not in the list
Register the destination in the address book (see page
50).
3
Select the destination from the list and press the k
(OUT) button.
You are returned to the SEND CLIP screen, which
displays the data for the selected destination.
4
Check that the destination is correct, and press the K
(IN) button twice to return to the SEND CLIP screen.
5
Select CLIP and press the k (OUT) button.
The normal screen appears on the monitor.
6
Use the playback, search, and clip jump functions to
find the clip that you want to send.
7
Press the SET button when the number of the clip that
you want to send appears in the CLIP SEL section at
the bottom of the monitor or in the time counter
display.
You are returned to the SEND CLIP screen, which
displays the number and duration of the selected clip.
Note
Clips cannot be selected while they are being
recorded. If you select a clip that is being recorded, a
warning message appears asking you to select another
clip.
8
Press the SET button.
Preparations for communications start.
When the preparations finish, the message “Issuing
transfer request. Will begin transfer after the end of
transfer standby.” appears.
Up to 29 transfer requests can be placed on standby.
When the 30th request is issued, the message
“Request queue full. Cannot send clip.” appears and
the transfer is rejected.
To cancel the transfer
In step 8, press the MENU button instead of the SET
button.
>Clip NETWORK MENU
SEND
CLIP
CLIPLIST A/V/TC/CM
ADDRESS BOOK
Time counter display
Monitor screen
SEND CLIP
< 01: AAAAAAAA >
HOST: HOST2
CLIP: 00001
DUR : 0:02:12:20
SEND : SET KEY
TO MENU : MENU KEY
Transfer destination host
a)
Number of clip to send b)
Duration of clip to send c)
a) “--------” is displayed when no destination host is selected.
b) “----” is displayed when no clip is selected.
c) “0: 00: 00: 00” is displayed when no clip is selected.
SEND ADDRESS BOOK
< 01: AAAAAAAA >
HOST: BBBBBBBB >
CLIP: 0001
DUR : 0:02:12:20
CLIP SEL 00001
TCR 00:01:01:12
Clip 00001
Time counter display
Monitor screen