Sony DSR-DR1000A - Manual (Page 61)

61
Menu Contents
Ch
ap
te
r 6
Men
u
Set
tin
g
Menu Contents
Setup Menu
The purpose and settings of the setup menu items are
described below.
Indications of menu items and settings
• In the table below entitled “Menu contents,” the
indication of each menu item or setting on the monitor
screen is shown first, then the indication of the same item
or setting in the time counter display of this unit is shown
in square brackets ([ ]).
• Settings preceded by an asterisk (such as *EE) are
factory default settings.
• In the time counter display, one to three “>” symbols
may precede item or setting indications depending on the
current menu level. Larger numbers of “>” symbols
indicate lower menu levels.
Menu contents
Examples:
Indication on monitor
screen Indication in time counter
display
OPERATIONAL FUNCTION [Operational]
* EE [>>> EE]
OPERATIONAL FUNCTION [Operational]: Operation settings Description of settings
REPEAT FUNCTION [> REP
FUNC]:
Make settings for repeat
playback mode.
REPEAT MODE [>> REPEAT
MD]:
Determine whether or not to
put the unit into repeat
playback mode.
* OFF [>>> OFF]: Do not put the unit into repeat playback
mode.
ON [>>> ON]: Put the unit into repeat playback mode.
REPEAT TOP [>> REP TOP]:
Determine whether the
repeat start point is the
beginning of disk or point A.
* VIDEO TOP [>>> Video top]: The repeat start point is
the beginning of disk.
A POINT [>>> A point]: The repeat start point is point A
as set by the user.
REPEAT END [>> REP END]:
Determine whether the
repeat end point is the end
of the video recorded
portion or point B.
* VIDEO END [>>> VD end]: The repeat end point is the
end of the video recorded portion.
B POINT [>>> B point]: The repeat end point is point B
as set by the user.
A PRESET [>> A preset]:
Specify a time code value to
be used as the setting of
point A.
For details, see “Setting Points A and B for Repeat
Playback” on page 36.
B PRESET [>> B preset]:
Specify a time code value to
be used as the setting of
point B.
For details, see “Setting Points A and B for Repeat
Playback” on page 36.
AUTO EE SELECT [> Auto EE]:
Determine whether the unit
enters EE mode or PB mode
when audio and video
signals from other equipment
are input.
When this unit is used as the
recorder for cut editing, it is
possible to output the input
audio and video signals to
the monitor. This enables
editing operation to be
carried out using a single
monitor.
F. FWD/REW [>> F. FWD/
REW]:
Operations when in fast
forward or rewind mode
EE [>>> EE]: Output video and audio signals received
from other equipment.
* PB [>>> PB]: The unit enters playback mode and
outputs a playback video signal. Audio signals are
muted.
STOP [>> STOP]: Operations
when in stop mode
EE [>>> EE]: Output video and audio signals received
from other equipment.
* PB [>>> PB]: The unit enters playback mode and
outputs a still picture.
STANDBY OFF [>> STBY
OFF]:
Operations when in standby
off mode
EE [>>> EE]: Output video and audio signals received
from other equipment.
* PB [>>> PB]: The unit enters playback mode and
outputs a still picture.