How to add the fabric softener, How to put the detergent in, Water supply connector filter – Samsung WA80R3 User Manual

Page 12: Pull out the filter and wash well, Push up and pull out the filter net, Open the cover as shown in the figure, Remove the collected lint from the filter net, Clean the magic filter, Clean the filter net, Pull down the filter net

Advertising
background image

- 12 -

HOW TO ADD THE FABRIC SOFTENER

HOW TO PUT THE DETERGENT IN

1. Open the detergent box by pulling in the direction of the arrow as shown in

the figure and then put the powder detergent in the detergent box.

2. Put in one-time amount of detergent evenly so the detergent may not brim

over the box.

CAUTION : If softener is stored over the above base line, it may flow down at

any time.

WATER SUPPLY CONNECTOR FILTER

CLEANING THE FILTER

Clean the filter net often to keep the washer clean.

HOW TO CLEAN THE PUMP FILTER

When a proper amount (one time does) of fabric softener is
stored in the softener inlet, it is automatically put in at the last
rinsing cycle.

Do not use detergent, bleach or starch into the Softener Inlet.

Using too much softener may produce
unsatisfactory results.

Do not open the lid during the Spin Dry cycle. If
added too early, its effectiveness will decrease.

Do not leave the softener into the Softener.
Dispenser for a long time. Because softner
became stiff.

1. Pull out the filter and

wash well.

2. Pull in the filter and

connect the hose to the
inlet water valve tightly.

3. Check if there is a

leakage.
Note to tighten up
the connector.

Detergent Device
Put the
detergent in proportion
to Water level

Softener
baseline

Softener Device

••••••••••

••••••••

••••••••••••••••••••

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

inlet water
valve

1. Push the upper part of the Magic

filter and pull in.

1. Push up and pull out the filter net.

2. Open the cover as shown in the

figure.

2. Remove the collected lint from the

filter net.

3. Clean the Magic filter.

3. Clean the filter net.

4. Close the cover and insert the

lower part of the filter in the
basket first and then push the
filter with “click” sound.

4. Pull down the filter net.

1. Place a rag under the washer filter not to

wet the floor.

2. Rotate the filter counterclockwise and pull

out the filter.

3. Remove dirts and rotate the filter clockwise

until it locks in position.

Advertising
This manual is related to the following products: